The Most In-Demand Cisco 350-401 Pass Guaranteed Quiz
New Version 350-401 Certificate & Helpful Exam Dumps is Online
Cisco 350-401 (Implementing Cisco Enterprise Network Core Technologies) Exam is a certification exam designed to test the knowledge and skills of IT professionals who work with Cisco enterprise network technologies. It is a part of the Cisco Certified Network Professional (CCNP) and Cisco Certified Specialist - Enterprise Core certifications. Passing 350-401 exam is a crucial step towards advancing one's career in the field of networking.
Virtualization (10%)
- Configuring and verifying the information path virtualization technologies such as virtual routing and forwarding as well as IPsec and GRE tunneling;
- Describing 1 and 2 types of hypervisor as well as virtual switching & virtual machine;
- Describing the network virtualization concepts, including LISP and VXLAN.
NEW QUESTION # 427
An engineer must configure a new WLAN that allows a user to enter a passphrase and provides forward secrecy as a security measure. Which Layer 2 WLAN configuration is required on the Cisco WLC?
- A. WPA3 Enterprise
- B. WPA3 Personal
- C. WPA2 Enterprise
- D. WPA2 Personal
Answer: B
Explanation:
WPA3 Personal is the correct configuration for a WLAN that requires a passphrase for user access and provides forward secrecy, which ensures that session keys cannot be compromised even if the long-term secret keys are compromised. WPA3 enhances security over WPA2 by using the Simultaneous Authentication of Equals (SAE) protocol, which replaces the Pre-Shared Key (PSK) exchange mechanism. References:
Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR) training
NEW QUESTION # 428
If AP power level is increased from 25 mW to 100 mW. what is the power difference in dBm?
- A. 20 dBm
- B. 17 dBm
- C. 14 dBm
- D. 6 dBm
Answer: B
Explanation:
The power difference in dBm can be calculated using the formula:
10×log10(P1P2)
where (P1) and (P2) are the initial and final power levels in milliwatts (mW). So, for an increase from 25 mW to 100 mW, the calculation is
10×log10(25100)=10×log10(4)=10×0.6=6dBm
However, since the question asks for the difference, we need to consider that dBm is a logarithmic unit, so we use the formula for power ratio in dB which is
10×log10(PowerRatio)
The power ratio here is
25mW100mW=4
Therefore,
10×log10(4)=10×0.6=6dBm
But this is the increase for each doubling of power. Since we are increasing from 25 mW to 100 mW, which is a fourfold increase or two doublings (25 mW to 50 mW to 100 mW), we have two increments of 6 dBm, which gives us a total increase of 12 dBm. However, the closest answer to 12 dBm is 17 dBm, which is answer
C: References: Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR) training materials
NEW QUESTION # 429
Refer to the exhibit.
Which HTTP JSON response does the python code output give?
- A. 7.0(3)I7(4)
- B. 7.61
- C. KeyError 'kickstart_ver_str'
- D. NameError: name 'json' is not defined
Answer: A
NEW QUESTION # 430
A network administrator is implementing a routing configuration change and enables routing debugs to track routing behavior during the change. The logging output on the terminal is interrupting the command typing process.
Which two actions can the network administrator take to minimize the possibility of typing commands incorrectly? (Choose two.)
- A. Configure the logging synchronous global configuration command.
- B. Configure the logging synchronous command under the vty.
- C. Increase the number of lines on the screen using the terminal length command.
- D. Configure the logging delimiter feature.
- E. Press the TAB key to reprint the command in a new line.
Answer: B,E
NEW QUESTION # 431
What is a characteristic of Cisco SD-WAN?
- A. uses unique per-device feature templates
- B. requires manual secure tunnel configuration
- C. uses control plane connections between routers
- D. operates over DTLS/TLS authenticated and secured tunnels
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/security/vedge/security- book.pdf
NEW QUESTION # 432
Which action is performed by Link Management Protocol In a Cisco StackWise Virtual domain?
- A. It rejects any unidirectional link traffic forwarding.
- B. It discovers the StackWise domain and brings up SVL interfaces.
- C. It determines which switch becomes active or standby.
- D. it determines if the hardware Is compatible to form the StackWise Virtual domain.
Answer: A
Explanation:
Explanation
The Link Management Protocol (LMP) performs the following functions: + Verifies link integrity by establishing bidirectional traffic forwarding, and rejects any unidirectional links + Exchanges periodic hellos to monitor and maintain the health of the links + Negotiates the version of StackWise Virtual header between the switches StackWise Virtual link role resolution Reference:
https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-9000/nb-06-cat-9k-stack-wp-cte-en.html
NEW QUESTION # 433
Drag and drop the code snippets from the bottom onto the blanks in the script to convert a Python object into a JSON string. Not all options are used.
Answer:
Explanation:
Explanation:
obj = json.JSONEncoder().encode(data)
NEW QUESTION # 434
Which two solutions are used for backing up a Cisco DNA Center Assurance database? (Choose two)
- A. bare metal server
- B. local server
- C. non-linux server
- D. NFS share
- E. remote server
Answer: D,E
Explanation:
Cisco DNA Center creates the backup files and posts them to a remote server. Each backup is uniquely stored using the UUID as the directory name.To support Assurance data backups, the server must be a Linux-based NFS server that meets the following requirements: - Support NFS v4 and NFS v3. - Cisco DNA Center stores backup copies of Assurance data on an external NFS device and automation data on an external remote sync (rsync) target location. - The remote share for backing up an Assurance database (NDP) must be an NFS share.
NEW QUESTION # 435
Refer to the exhibit.
Which privilege level is assigned to VTY users?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
Explanation:
Lines (CON, AUX, VTY) default to level 1 privileges.
NEW QUESTION # 436
Refer to the exhibit.
A network architect has partially configured static NAT. which commands should be asked to complete the configuration?
- A. R1(config)#interface GigabitEthernet0/0 R1(config)#ip nat inside
R1(config)#interface GigabitEthernet0/1 R1(config)#ip nat outside - B. R1(config)#interface GigabitEthernet0/0 R1(config)#ip pat outside
R1(config)#interface GigabitEthernet0/1 R1(config)#ip pat inside - C. R1(config)#interface GigabitEthernet0/0 R1(config)#ip nat outside
R1(config)#interface GigabitEthernet0/1 R1(config)#ip nat inside - D. R1(config)#interface GigabitEthernet0/0 R1(config)#ip pat inside
R1(config)#interface GigabitEthernet0/1 R1(config)#ip pat outside
Answer: C
NEW QUESTION # 437
Drag and drop the characteristics from the left onto the switching architectures on the right.
Answer:
Explanation:
NEW QUESTION # 438
Which entity
is responsible for maintaining Layer 2 isolation between segments In a VXLAN environment?
- A. VNID
- B. switch fabric
- C. host switch
- D. VTEP
Answer: A
Explanation:
NEW QUESTION # 439
Drag and drop the threat defense solutions from the left onto their descriptions on the right.
Answer:
Explanation:
Explanation
NEW QUESTION # 440
Refer to the exhibit. Which configuration must be applied to R1 to enable R1 to reach the server at 172.16.0.1?
- A.
- B.
- C.
- D.
Answer: C
NEW QUESTION # 441
Drag and Drop Question
Refer to the exhibit. An engineer must deny HTTP traffic from host A to host B while allowing all other communication between the hosts. Drag and drop the commands into the configuration to achieve these results. Some commands may be used more than once. Not all commands are used.
Answer:
Explanation:
NEW QUESTION # 442
What is a command-line tool for consuming REST APIs?
- A. Python requests
- B. Postman
- C. Firefox
- D. CURL
Answer: D
Explanation:
CURL is a versatile command-line tool used for transferring data with various protocols, including HTTP. It is widely used for consuming REST APIs, allowing developers to send requests and receive responses directly from the command line.
NEW QUESTION # 443
Which type of ACL can be applied only to Layer 2 pods?
- A. reflexive ACLs
- B. port ACLs
- C. VLAN ACLs
- D. dynamic ACLs
- E. reflexive ACLs
Answer: B
NEW QUESTION # 444
Which statement about an RSPAN session configuration is true?
- A. A special VLAN type must be used as the RSPAN destination.
- B. A fitter mutt be configured for RSPAN Regions
- C. Only incoming traffic can be monitored
- D. Only one session can be configured at a time
Answer: A
Explanation:
The traffic for each RSPAN session is carried over a user-specified RSPAN VLAN that is dedicated for thatRSPAN session in all participating switches -> This VLAN can be considered a special VLAN type -> Answer'A special VLAN type must be used as the RSPAN destination' is correct.
NEW QUESTION # 445
A network monitoring system uses SNMP polling to record the statistics of router interfaces The SNMP queries work as expected until an engineer installs a new interface and reloads the router After this action, all SNMP queries for the router fail What is the cause of this issue?
- A. The SNMP community is configured incorrectly
- B. The SNMP interface index changed after reboot.
- C. The SNMP server traps are disabled for the link state.
- D. The SNMP server traps are disabled for the interface index
Answer: B
Explanation:
SNMP interface indexes are dynamically assigned when a router boots up. If a new interface is installed and the router is reloaded, the SNMP interface index may change, which can cause SNMP queries to fail because the monitoring system is polling the wrong index.
NEW QUESTION # 446
Which feature is supported by EIGRP but is not supported by OSPF?
- A. unequal-cost load balancing
- B. route summarization
- C. equal-cost load balancing
- D. route filtering
Answer: A
Explanation:
EIGRP support unequal-cost load balancing via the "variance ..." while OSPF only supports equalcost
load balancing.
NEW QUESTION # 447
What is calculated using the numerical values of the transmitter power level, cable loss, and antenna gain?
- A. SNR
- B. RSSI
- C. EIRP
- D. dBi
Answer: C
Explanation:
Once you know the complete combination of transmitter power level, the length of cable, and the antenna gain, you can figure out the actual power level that will be radiated from the antenna. This is known as the effective isotropic radiated power (EIRP), measured in dBm.
EIRP is a very important parameter because it is regulated by governmental agencies in most countries. In those cases, a system cannot radiate signals higher than a maximum allowable EIRP. To find the EIRP of a system, simply add the transmitter power level to the antenna gain and subtract the cable loss.
NEW QUESTION # 448
Refer to the exhibit.
An engineer must prevent the R6 loopback from getting into Area 2 and Area 3 from Area 0 Which action must the engineer take?
- A. Apply a filter list inbound on R3 and R7
- B. Apply a filter list outbound on R7 only.
- C. Apply a filter list outbound on R3 and R7
- D. Apply a fitter list inbound on R2 and R9
Answer: C
Explanation:
This question asks to prevent route advertised into Area 2 and Area 3 only. It does not ask to prevent route advertised into Area 0 so applying a filter list outbound on R3 and R7 would best fit the requirement.
NEW QUESTION # 449
......
Cisco 350-401 certification exam, also known as Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR), is a comprehensive exam that tests the knowledge and skills required to implement and troubleshoot enterprise network infrastructure. Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) certification is designed for network engineers, network administrators, and network architects who want to upgrade their skills and knowledge in enterprise networking. 350-401 exam covers a wide range of topics, including network security, automation, virtualization, and network design.
350-401 Free Certification Exam Material with 1282 Q&As : https://www.prep4sures.top/350-401-exam-dumps-torrent.html
UPDATED 350-401 Exam Questions Certification Test Engine to PDF: https://drive.google.com/open?id=166WpBEX5JJ70H2OeBLxmh2FRBVUb0H1T